TESTER 1006

Weighing Instrumentation Weight Transmitters

DOWNLOADS

Datasheet

For the simultaneous control of up to 4 load cells in any weighing system
Direct operation as Calibrator and peak detector
Upload and download function for programming tools and DAT series MC 302
For the correct mechanical installation and fault diagnosis
Comes with cable for connection to our junction boxes / sum mod. CEM 4 / C and CGS 4 / C
The simultaneous display of each individual load cell signal is used to control the entire weighing system, the weight distribution, overloads, the faulty cells or faulty connections

Encoder supply:	5 VDC / 60 mA (max 4 x 350 ohm cells in parallel)
Measuring range:	from -3.9 to +3.9 mV / V
Linearity:	<0.01% of full scale
Temperature drift:	<0.001% FS / ° C
Display:	Chart 3 "
A / D converter:	24 bits
Internal resolution:	> 16,000,000 points
Viewable resolution:	50,000 divisions
Divisions value (selectable):	x1, x2, x5
Settable decimal:	0.0; 0.00; 0,000
Keyboard:	16 buttons + on / off
Power tool:	4 AA batteries - Power consumption 5 W
Absorption:	125 ÷ 190 mA
Autonomy:	about 4 hours with alkaline batteries, about 8 hours with rechargeable Ni-MH 1.2 V (2000 mAh)
Operating temperature:	-10 To +50 ° C (max 85% humidity non-condensing)
Storage temperature:	-20 To +70 ° C
Degree of protection:	IP54
Weight:	500 g approx
Connections to the load cells:	Sub-D 25-pin connector and its cable length 2m
Tools connections:	Sub-D 25-pin connector and cable length 0.5m
CALIBRATOR
Precision:	0.033% of FS
Supply voltage cells:	3 ÷ 12 Vdc
Signal:	-3 ÷ +20.3 mV
Impedance:	Selectable 350/700 Ohm, or set 300 to 4500 Ohm