DAT 200/ETHERNET

Weighing Instrumentation Weight Transmitters

DOWNLOADS

Datasheet

High performance and long-term reliability
Mounting "snap-on" DIN rail (EN50022)
Configuration and calibration from the front panel
Calibration certificates executable with the transducers, or with known weights
RS232 serial output, ASCII protocols, MODBUS
The width dimensions allow to place a large number of transmitters within the electrical automation panels
Interfacing with barriers Intrinsically Safe for use in hazardous areas

transducers Power:	4 V (max 4 x 350 ohm cells)
Measuring range:	-4 to +4 mV / V
Input sensitivity:	00:02 V / division
Linearity:	<0.01% FS
Thermal drift:	<0.001% FS / ° C
Display:	5 digits, red 7-segment LED, height 7 mm
Status LEDs:	2 red
A / D converter:	24-bit
Internal resolution:	of 16,000,000 points
Viewable resolution:	60,000 displayable divisions on net weight
Divisions Value:	0001 ÷ 50 selectable
Filter:	0.02 to 25 Hz Selectable
Keyboard:	3 mechanical buttons (behind the red door)
Power tool:	24 Vdc ± 10% - input power 2 W
Operating temperature:	-10 / + 50 ° C (max 85% relative humidity without condensation)
Storage temperature:	-20 / + 60 ° C
Serial port:	RS232 half duplex with ASCII protocol
Baud rate:	2400 ÷ 115200 Selectable
Transmission distance:	15 m
Direct protocol to fieldbus:	10/100 Ethernet with TCP, MODBUS / TCP, IP
Buffer Size	IN 128 bytes - 128 bytes OUT
Regulatory Compliance:	EN61000-6-2, EN61000-6-3 EMC; EN61010-1 for Electrical Safety
Electric connections:	Terminal Blocks 5.08 mm pitch screw RJ45 connector