DAT 100/ANALOG

Weighing Instrumentation Weight Transmitters

DOWNLOADS

Datasheet

High performance and long-term reliability
Mounting "snap-on" DIN rail (EN50022)
ANALOG Output
Configuration and calibration executable from the front panel with the certificates of the transducers, or with known weights
2 logic inputs and 2 outputs Relay
RS232 serial outputs, ASCII and Modbus RTU protocols
The width dimensions allow to place a large number of transmitters within the electrical automation panels
Interfacing with barriers Intrinsically Safe for use in hazardous areas

transducers Power:	4 V (max 4 x 350 ohm cells)
Measuring range:	-4 to +4 mV / V
Input sensitivity:	00:02 V / division
Linearity:	<0.01% FS
Thermal drift:	<0.001% FS / ° C
Display:	5 digits, red 7-segment LED, height 7 mm
Status LEDs:	2 red
A / D converter:	24-bit
Internal resolution:	of 16,000,000 points
Viewable resolution:	60,000 displayable divisions on net weight
Divisions value (selectable):	0001 ÷ 50
Filter:	selectable 0.2 to 25 Hz
Keyboard:	3 mechanical buttons (behind the red door)
Power tool:	24 Vdc ± 10% - input power 2 W
Operating temperature:	-10 ÷ + 50 ° C (max 85% relative humidity without condensation)
Storage temperature:	-20 ÷ + 60 ° C
Logic outputs:	2 optisolate; MAX 24 VDC / 100 mA cad
Logic inputs:	2 optoisolated PNP at 24 VDC (external power supply)
Serial Ports:	RS232 half duplex with ASCII protocol or Modbus RTU full duplex RS485 with ASCII protocol or Modbus RTU
Baud rate:	2400 ÷ 115200 Selectable
Transmission distance:	15 m
Analog output:	optoisolated to 16 Bit
Voltage:	0 ÷ 5 / 10V (R min10 K Ohm)
Current:	0/4 ÷ 20mA (R max 300 Ohm)
Linearity:	<0,03% FS
Thermal drift:	<0.002% FS
Regulatory Compliance:	EN61000-6-2, EN61000-6-3 EMC; EN61010-1 for Electrical Safety
Electric connections:	Screw terminal blocks 5.08 mm pitch